Hi friends,

We’re sharing our third Sonic post with you! We previously shared Sonic: Tails & Sonic The Hedgehog, and now we bring you, Sonic: Dr. Eggman. Dr. Eggman is our first villain; unless you count the spiders we’ve made over the years haha, and one of Sonic’s enemies. Check out our 2 versions of Dr. Eggman and how to make them 3D as well.

*Click on photos for a closer look

What You'll Need

White Paper Plate
Whole Sheet of Brown Construction Paper, Off White/Tan Drawing Paper
(1/2) Sheet Of Pink, White, Blue, & Black Construction Papers
Scissors
Pencil & White Colored Pencil
Black Pen
Glue
Optional: Medicine Cup

The Steps

FACE

Trace the plate onto the tan(drawing paper) and cut it out.
Glue the paper onto the front of the plate.

GOGGLES

Fold the black half-sheet in half.
Draw your goggles at an angle, 4-5 inches wide x 3 inches high. The center band should be facing the folded part.
Cut the goggles out and glue them to the top part of the head.

EYES/NOSE

EYES: Draw 2 (2-inch) circles on the blue paper or use a larger medicine cup to trace and cut out the rounds.
NOSE: Fold your pink half-sheet in half, draw the nose, and cut it out. Set the nose and eyes aside.

MUSTACHE

Fold your full sheet of brown paper in half lengthwise, into a narrow piece, and then again in half(1/4 size).
Open up the brown paper:
3D Mustache- glue only a 2-inch wide section on each side of the shorter crease, when it’s cut out the bushy part will be in 2 layers.
Flat Mustache- glue all of the insides, when it’s cut out it will be one solid piece.
Fold the paper back up into the 1/4th size, draw the flat part of the mustache from the narrow folded side, and extend the bushy end as close to the edges.
Cut out the mustache and set it aside temporarily.

MOUTH/TEETH

Fold your white half-sheet in half and trace the edge of the plate starting from the fold, out to the outer edge.
Cut the mouth out and draw only the upper teeth(far right) or both upper/lower teeth (inner right), then trace with the black pen.